Slashdot
I have created an axel hub assembly. Thankfully the bearings used were matched to SKF Bearing Part Numbers. Inventor is so swar. Notice also the rod end bearing. This came from the Cbliss site in the iParts section. I have modified it so that it can be moved. It had to be separated into two parts to do this, the ball and the cup. The spline on the end of the axel is temporary. I don't have any wheels yet, nor do I have any specs or drawings to base my axel off. It's a guestimate. There is also a hole in the side of the hub body. This is to access the grub screw in the retainer ring that holds in place the axel and retains the bearings. The cup of the universal joint is also temporary. I haven't worked out any degrees of movement or the forces in place to design the drive shafts or drive couplings.
|
|
| ||||
|
|
|
