Router Table Gallery
Roundover Test
Dec. 31, 2009, 5:20 p.m.
Ready to put the hole in with a 19mm straight bit
Dec. 31, 2009, 4:14 p.m.
Tri-wing knob with through-hole
Dec. 31, 2009, 6:04 p.m.
Slots cut for fence
Dec. 31, 2009, 8:30 p.m.
10mm Straight Bit and 3/8" Bolt
Dec. 31, 2009, 6:09 p.m.
Preparing the tri-wing knobs
Dec. 31, 2009, 5:52 p.m.
Push Block - Handle Dovetail
Jan. 3, 2010, 3:08 p.m.
Push Block - Under-Side View
Jan. 3, 2010, 3:09 p.m.
Bolt Retainer and Slide Block Idea
Jan. 1, 2010, 10:39 p.m.
Marked Out
Jan. 2, 2010, 10:18 a.m.
Horribly ground retainers
Jan. 2, 2010, 11:26 a.m.
Retainers after lots of filing
Jan. 2, 2010, 12:23 p.m.
Retainers after lots of filing - Bolt in Place
Jan. 2, 2010, 12:35 p.m.
Router Trigger Switch Dead
Jan. 2, 2010, 1:11 p.m.
Slide block test fit before being cut
Jan. 2, 2010, 1:57 p.m.
Slide Block Assembled
Jan. 2, 2010, 2:16 p.m.
Fence in Place and Fence with Chip Break
Jan. 2, 2010, 3:14 p.m.
It didn't quite divide out to 10mm
Jan. 3, 2010, 4:30 p.m.
Sample fence in place
Dec. 31, 2009, 8:35 p.m.
Pushed the 10mm roundover all the way through gives ~25mm
Dec. 31, 2009, 5:03 p.m.
Set up to cut slot in slide block for retainers
Jan. 2, 2010, 1:57 p.m.
Slide Block Assembled and Crimped
Jan. 2, 2010, 2:19 p.m.
Box Joint - Cut Deeper, Sand Flush.
Jan. 3, 2010, 4:27 p.m.
Push Block - Sacrificial Front and Box Joint Jig
Jan. 3, 2010, 4:27 p.m.
Router Screwed In 2
Dec. 31, 2009, 4:13 p.m.
Router Screwed In
Dec. 31, 2009, 4:13 p.m.
Push Block
Jan. 3, 2010, 3:08 p.m.
Login to create a new gallery.