Zagadka's Site

Tonight I fired up the high voltage power supply and had a go at getting this EM84 display tube going.

+250VDC on the anode, The grid is being operated between -20VDC and 0VDC. The heater on this tube is 6.3V.

Positive terminal on an isolated bench supply is connected to the ground of the +250V supply to give negative voltage required to drive the grid. The negative is fed into pin 1 via a 1meg resistor to ground.

As the grid voltage aproaches 0V, the shadow widens. I put up this video demonstrating adjustment of the grid.