Slashdot
11:00 AM:
Dump iParts on web server quick! A not-so-busy morning at work. Boooooring. I did draw a slide switch and the cut-out of the zippy box in some spare time. Also, I dumped an image of the square push button for your viewing pleasure.
2:00 PM:
Finished the cut-out of the lid ready to start assembling!
3:00 PM:
Another update. We have a win. I have almost finished my 3D model.
I think based on this, I may be able to put the project in the next size down Zippy Box. Then it will be a bit smaller, then again, it's: a) a prototype and b) not supposed to be hand-held. There will be a remote release attached to this as well for manual shooting. The remote-remote will be smaller and "hand-held" with two buttons. One button will control AF/AE (Auto Focus/Auto Exposure) depending on the mode of the camera and the remote release, the other will control the shutter.
So that's done, now what. Next I have to draw the connector I will be using. It is an 8 pin mic plug. Very heavy duty and solid. 8 pins for redundancy, only three will be used to start with. Depends if I add pretty LEDs and crap to the remote...
The layout. Yes, it's not even. That will come later.
Components:
5 x P7552 - Square push buttons.
These will be used for navigation through the menu system. They will be up, down, left, right and in the center; set.
3 x P7610 DPDT Slide Switches.
The first will be used to switch between "set" mode and "run" mode. The second will be used to set "Manual" or "Controller" shooting. The third will control the backligths and LEDs, incase they interfere with a low-light shot.
The menus are designed. I just need to code the damn thing now. But first, the prototype!